UP. 1.1 Decolers (10 tonnes) (3 units) andУП 1.2 Hydraulic driven undercarriages (3 units)

Decolers are designed for continuous uncoiling of sheet metal from the coil on a sandwich panel production line. The feed speed of the thin sheet metal coil is automatically adjusted.

Specification

  • Length, mm: 2610
  • Width, mm.: 1200
  • Height, mm.: 1160
  • Weight, kg.: 2700
  • Roll weight, т: До 10
  • Mains voltage, V - Hz : 220/380В-50Гц
  • Power consumption, kW: 4
Message us

View other modules and sections of sandwich panel continuous laminating production lines

UG. 3.10 Dust extruction unit (XXX m3/hour)

UG. 3.10 Dust extruction unit (XXX m3/hour)

Dust extruction unit is designed to remove mineral wool swarf and dust from the cutting area.The contaminated air, together with the swarf from the work area, is conveyed by a fan through suction hoses to the unit, where larger dust particles are blown against the housing walls, lose speed and fall into the dust collector. […]

KL.4.1 Thickness calibration module

KL.4.1 Thickness calibration module

Thickness calibration module is designed to calibrate the thickness of a mineral wool board. Mineral wool thickness pre-calibration allows the production of mineral wool boards with the same geometric dimensions, which in turn reduces the load on the cutters of the disc cutoff block.

UP.1.5 Trapeze lamella multiblade disc saw

UP.1.5 Trapeze lamella multiblade disc saw

Trapeze lamella multiblade disc saw is designed to cut the mineral wool panel into trapezoidal lamellas, which are then placed in the bottom lining of the roof sandwich panel.

KL. 4.5 Core pushing table

KL. 4.5 Core pushing table

Core pushing table is designed for continuous feeding of the mineral wool slats into the line. The lamellas are joined to form a continuous staggered mineral wool mat in according to Interstate Standard (GOST).

UG. 3.11 Turn over unit

UG. 3.11 Turn over unit

Turn over unit is designed to turn the finished roof sandwich panels, which are then stacked into a stack with the ribs facing each other. This reduces the height of the finished pile of shipped products and prevent damage to the edges of the panels during further transportation.

UP. 1.11 Deep Profiled Roof module

UP. 1.11 Deep Profiled Roof module

Deep Profiled Roof module is designed for the manufacture of the bottom flashing for a roof sandwich panel.Deep Profiled Roof module is designed for the manufacture of the bottom flashing for a roof sandwich panel.

Sandwich panel production lines

«Optimal»

Provides a high degree of automation and a wide range of output product

«Basic»

Provides the possibility of further modernization and guaranteed quality of output product

Warranty service for 12 months from the date of launching the line.

Installation and commissioning

Post-warranty service and technical support

Post-warranty service and technical support

Do you have a non-standard project? Contact us

Do you want to know more about our sandwich panel lines technology? Send us your enquiry.
Our team will promptly contact you to provide you more information and follow your needs.

Nevskiy Oleg

Nevskiy Oleg

Sales Director
Message us
Nevskiy Oleg

Nevskiy Oleg

Sales Director

Thanks! Your application has been accepted

Our specialist will call you back during the day