UP.1.5 Trapeze lamella multiblade disc saw
Trapeze lamella multiblade disc saw is designed to cut the mineral wool panel into trapezoidal lamellas, which are then placed in the bottom lining of the roof sandwich panel.
View other modules and sections of sandwich panel continuous laminating production lines
KL.4.7 Reception roller conveyor
Reception roller conveyor is a driven roller conveyor with guides, designed for receiving lamellas of mineral wool boards.
UG. 3.11 Turn over unit
Turn over unit is designed to turn the finished roof sandwich panels, which are then stacked into a stack with the ribs facing each other. This reduces the height of the finished pile of shipped products and prevent damage to the edges of the panels during further transportation.
KL.4.6 Buffer roller conveyor
Buffer roller conveyor is a driven roller conveyor with guides, designed for handling lamellas of mineral wool boards.
UG. 3.10 Dust extruction unit (XXX m3/hour)
Dust extruction unit is designed to remove mineral wool swarf and dust from the cutting area.The contaminated air, together with the swarf from the work area, is conveyed by a fan through suction hoses to the unit, where larger dust particles are blown against the housing walls, lose speed and fall into the dust collector. […]
US. 2.1 Laminator
Laminator forms sandwich panel locks, applies adhesive, brings together the cladding and the mineral wool mat for subsequent feeding into the press.
UP. 1.12 Disc cutoff block
Disc cutoff block is designed for milling “quarters” for locks on the lining of sandwich panels, as well as calibration of the width of the mineral wool mat.
Sandwich panel production lines
«Basic»
Provides the possibility of further modernization and guaranteed quality of output product
Warranty service for 12 months from the date of launching the line.
Installation and commissioning
Post-warranty service and technical support
Post-warranty service and technical support
