KL. 4.15 Multi-blade disc lamella saw

Multi-blade disc lamella saw is designed for cutting mineral wool boards into lamellas of a given width. It is completed with interchangeable shafts for adjustment to the desired lamella width.

Specification

  • Length, mm: 1530
  • Width, mm.: 2090
  • Height, mm.: 1620
  • Weight, kg.: 1180
  • Mains voltage, V - Hz : 220/380В-50Гц
  • Power consumption, kW: 13,2
The use of saw blades with a special tooth configuration designed for cutting mineral wool panels. This configuration ensures a clean cut and does not tear the material to be cut. It is equipped with a pneumatic tensioner. The drive belts are tensioned when the material to be cut comes into play in the cutting zone. This function eliminates the possibility of accidental activation of the saw when there is no material to cut. It is equipped with guides built into the saw. This gives precise positioning of the material to be cut. Modularity of the saw. This allows it to be integrated into any existing production line. Advanced aspiration system removes the maximum amount of waste from the cutting area, which also ensures a clean cut and correct lamella geometry.
Message us

View other modules and sections of sandwich panel continuous laminating production lines

KL. 4.5 Core pushing table

KL. 4.5 Core pushing table

Core pushing table is designed for continuous feeding of the mineral wool slats into the line. The lamellas are joined to form a continuous staggered mineral wool mat in according to Interstate Standard (GOST).

UG. 3.11 Turn over unit

UG. 3.11 Turn over unit

Turn over unit is designed to turn the finished roof sandwich panels, which are then stacked into a stack with the ribs facing each other. This reduces the height of the finished pile of shipped products and prevent damage to the edges of the panels during further transportation.

US. 2.1 Laminator

US. 2.1 Laminator

Laminator forms sandwich panel locks, applies adhesive, brings together the cladding and the mineral wool mat for subsequent feeding into the press.

US.2.2.2 Adhesive components supply station

US.2.2.2 Adhesive components supply station

Adhesive components supply station is designed for supplying components, pre-mixing, dosing two-component polyurethane adhesive and its uniform application in the production of sandwich panels filled with mineral wool with liners of structured metal and glass wool on the lines of continuous operation.

UP. 1.11 Deep Profiled Roof module

UP. 1.11 Deep Profiled Roof module

Deep Profiled Roof module is designed for the manufacture of the bottom flashing for a roof sandwich panel.Deep Profiled Roof module is designed for the manufacture of the bottom flashing for a roof sandwich panel.

UP.1.5 Trapeze lamella multiblade disc saw

UP.1.5 Trapeze lamella multiblade disc saw

Trapeze lamella multiblade disc saw is designed to cut the mineral wool panel into trapezoidal lamellas, which are then placed in the bottom lining of the roof sandwich panel.

Sandwich panel production lines

«Optimal»

Provides a high degree of automation and a wide range of output product

«Basic»

Provides the possibility of further modernization and guaranteed quality of output product

Warranty service for 12 months from the date of launching the line.

Installation and commissioning

Post-warranty service and technical support

Post-warranty service and technical support

Do you have a non-standard project? Contact us

Do you want to know more about our sandwich panel lines technology? Send us your enquiry.
Our team will promptly contact you to provide you more information and follow your needs.

Nevskiy Oleg

Nevskiy Oleg

Sales Director
Message us
Nevskiy Oleg

Nevskiy Oleg

Sales Director

Thanks! Your application has been accepted

Our specialist will call you back during the day